Cold profiled, sendzimir galvanized steel, thickness 1,5 mm
with standard rollers
with wheel flange rollers
Upon customer’s request (max. 6500 mm)
33, 50, 66, 83, 100 mm ...
The divisions stated in the catalog are only approximate. The exact hole matrix of the roller edge is 16,667 mm ± 0,1 mm. Please state the desired division in your order and observe the stated tolerances.
If no special tolerance (T1) is ordered, the roller edges are always assembled to make sure that no roller stands out from the edge.
However, the roller commencement varies by the roller division. If the commencement should be at a precisely specified dimension, additional cutting costs will be charged.
If the roller commencement (T1) (center of axle) shall be precisely specified , this dimension can only be observed on this side. For the other side only a dimensions can be indicated that matures according to the length of the roller edge with the tolerances of the hole divisions (max. up to ± 8,5 mm).
Load of the rollers (Bearing Steel axle)
Load of the Roller Edge
Results from the section modulus in the main load level of 1,2 cm3.
–30 °C to +100 °C
Individual rolls, stop device, friction delaying stop device, connector – consisting of a U-profile mounted by 4 screws below the roller edge.
Deep freeze version from –30 °C
with high conductive rollers (black) to avoid static loads
Axle and profile of stainless steel
Axle only of stainless steel